| 
| Motors Motors:
Continuous duty rating, equipped with manual reset thermal overload inherent
protection. Permanently lubricated ball bearings for upper and lower shaft
support.
Housings
Housings: Heavy aluminum grind and discharge housings. Four bolts
fasten the motor unit to the grind chamber, permit easy removal.
Legs
Legs: Tubular
stainless steel with bullet feet to support housing. Adjustable to 3 inches in
either direction. |
|
Flywheel:
Offset breaker
blade, mounted at center, speeds grinding, prevents objects from "riding" at
center. Two hardened stainless steel cutter blocks (fastened to flywheel with
nylon locking screws) are replaceable, can be indexed for new cutting edges.
Corrosion resistant Ni-Resist flywheel is 7 3/16" diameter, slots undercut the
shredder ring to assure that particles are cut to proper size before passing to
the drain line. Motor Shaft
Seal:
Face-type seal consists of sintered bronze mating ring
and spring loaded carbon ring insert in chemical resistant neoprene bellows.
Mating surfaces are protected from grit or fibers by being recessed into
flywheel. Should any moisture pass this seal, a flinger and drain tube are
provided to insure immediate removal. In addition, a lip-type oil seal (located
beneath the bearings) is an "added protection" water seal. Mounting:
All Hobart Disposers
fasten to 7" I.D. (throat opening) cones. A vinyl isolating ring eliminates
metal-to-metal contact at the cone mounting, reduces vibration and noise
transmission. | Stationary
Shredder Ring: Abrasion resistant, Ni-Hard, 2 1/4" high, 4
machine ground primary action breaker bars, 42 secondary action grinding teeth.
Drain Connector:
The removable outlet flange is tapped for 2" pipe connection. Dual Directional Grinding:
Hobart Disposers operate in either direction of flywheel rotation. Direction of
rotation can be controlled by the operator (to increase life and efficiency of
grinding elements back flywheel free of a "jam") when installed with Control
Groups 2 or 3. Weight:
Shipping Approx. 95 lbs. (does not include accessory group or controls).
|
